|
Post by canuck on Jun 3, 2022 13:46:45 GMT
General query about MK 1 seat supports. The seat frame at the rear has two support posts with 'rubber' caps. Where these posts sit on the floor the OE carpet has a double thickness sewn in to help the carpet longevity. When I get my car the PO had put a bit of 'lumber' across these posts to what I thought was an attempt to raise the back of the seat for comfort. Being a tallish bloke I removed this bit of 'lumber' but found that these post now cut through the 'rubber' caps and add a 'dent' in the carpet. I have been thinking about correcting this shortcoming but never seem to get around to it. I was thinking of adding a mild steel wider foot to each rear post that maybe sockets into the post? Anyway fast forward to today and I came across this advert for a seat on an eBay auction. I am curious if any of you MK 1 car owners have done something similar? Salut Bruce
|
|
|
Post by ozieagle on Jun 4, 2022 0:18:37 GMT
Hi Bruce, Maybe your PO had cut down the seat, to give a more rakish position, like I did, way back on my Austin Lancer, and he found it too much and put the wood there to bring it back to standard, as I did. I have attached a photo of my Wooly's seat, for info. Herb
|
|
|
Post by 2robert4 on Jun 4, 2022 8:48:50 GMT
Hi Bruce
I obtained 2 walking stick rubber feet which incidentally fitted a treat and a thicker strip of sound insulation under the carpet this fix worked for me but I suppose it depends on one variable, the weight of the driver? Good luck in your endeavours.
NP
|
|
|
Post by canuck on Jun 4, 2022 14:16:29 GMT
Nigel, I measure 190 cm's and weigh in at just over 13 stone? shouldn't be the issue? however I will lay off the crisps this evening as I watch the Queens Platinum Jubilee concerts. I don't mind the seat rake as is. Long trips are 'painful' and sitting bandy legged for 3 hours is just enough to force a tea break. Years ago I also renewed the rubber caps to the seats and these work well, to a point. The 'posts' of the seat frame don't seem to align with the corrugations in the floor? The seat sits a bit cockeyed. FWIW I have the front locators in the rear most bolt holes position of the floorboard. @ Herb, That seat frame you show appears to be a MK 2or 3 frame that does not have these 'posts'. You are good to go. Bruce
|
|
|
Post by canuck on Jun 4, 2022 14:22:05 GMT
I mentioned in my post about the PO having bits of 'lumber' under these seat posts. I just came across these photos I had archived that show the wood supports. Salut Bruce
|
|
|
Post by ozieagle on Jun 4, 2022 21:08:24 GMT
Hi Bruce,
Those seats are in my 1958 Series I Wolseley and are identical to the seats in my 1958 Austin Lancer, I had in the mid 60s. Maybe in Oz they were different.
Herb
|
|
|
Post by canuck on Jun 5, 2022 13:32:49 GMT
Those seats are in my 1958 Series I Wolseley and are identical to the seats in my 1958 Austin Lancer, I had in the mid 60s. Maybe in Oz they were different. Evidently Herb, a different marque from/for a different market. FWIW the later MK Riley has a different seat frame from what you show. I may try something similar to the eBay offering in the 'off' season. Perhaps I will use a round bar versus a flat bar? the floor pan is on a downward slope where these seat 'posts' meet the floor. Salut B
|
|